Glass Retaining Wall Panel - 1200mm wide x 1400mm-1800mm high (Sloping to 1200mm high)

1 x Glass Retaining Wall Panel - 1200mm wide x 1400mm-1800mm high (Sloping to 1200mm high), 12mm thick. 

PLEASE NOTE: This high side of this glass panel will need a RIGI-clamp to connect it to a wall or glass panel to provide support. Please see this category: Joiners & Clamps

Note: Support spigots are sold separately. Plesae see this category: Spigots & Fixings 

Fence Guru™ glass pool fencing system is EASY for DIY installation: 

There are no bolt holes in the glass panel... meaning that the spigots are not required to be fitted to the glass panel in an exact position - this allows for easy adjustment. The spigots are a 'friction fit' meaning that the spigots are clamped tightly to the glass with two Allen key screws on the back of the spigot. The screws push a pressure plate hard onto the glass panel and firmly clamp it into place. If you need to move a panel slightly, or completely remove a panel for any reason, you can simply loosen the Allen key screws. The ability to slightly move a panel is so important, especially when it comes to fine tuning the opening for your glass gate and also for fine tuning the gaps between your glass panels. 

Fence Guru™ quality assurance:
Our glass panels and stainless spigots are supplied by National Australian Companies, who guarantee full compliance with Australian standards, (AS1926.1) and who also provide compliance certificates. 

Fence Guru™ glass panels:
Our clear toughened glass panels are 12mm thick and are made to Australian Standards. All glass panel edges and corners are beautifully polished and bevelled for the safest and best possible look. 

Recommended gaps:
We recommend that the gap between each glass panel be between 20 to 60mm. At the start and finish of each length also leave a gap of 20 to 60mm. Gap under the glass is normally around 50mm. 

Stainless steel maintenance:
Clean stainless steel regularly using a mild detergent and a soft brush to remove the build up of dirt, grime and salt deposits etc. Wash with a mild detergent and then rinse off with fresh water. Do not use heavy duty cleaners or strong household cleaner or solvents. Never use hydrochloric acid to clean stainless steel or cleaners that are acidic or alcohol based. Please note: if you are in a highly corrosive environment and choose not to regularly clean your stainless steel components you may get tea staining/discoloration on your stainless steel products.